Fender Upper and Lower Overlays
Sticker Fab's original fender overlays were designed for ease of installation. For those extremely particular about details and/or with lighter colored vehicles, this extended version installs pretty easily still and makes sure your vehicle's paint color cannot be seen from any angle period.
A little heat from a hair dryer or heat gun will seal the deal and allow you to wrap these overlays all around your fenders.
This modification gives your car unique, aftermarket styling with minimal effort.
SOLD AS A SET. Only 1 set required per vehicle. 2 or 4 pieces total. Does not include fender emblems.
Not All Materials are Created Equally
When purchasing vinyl overlays, keep in mind that not all materials are created equally. I use premium vinyl which has high initial costs, but are the industry standards for high quality materials. Also made in the USA.
Dragon Wrap™ Carbon Fiber Films (3D Carbon) is a 5.6 mil calendered vinyl film featuring a clear repositionable permanent acrylic adhesive on an air-egress liner. This film has excellent dimensional stability, outstanding durability and outdoor performance. This repositionable permanent adhesive offers minimal initial bond growing to permanent bonds that facilitates application of large graphics. The air egress liner also aids in large graphic application.
- Minimum application temperature is 40 degrees Fahrenheit. Up to 5 year durability outdoors.
- Rated EXCELLENT for WATER RESISTANCE, HUMIDITY RESISTANCE, and SOLVENT RESISTANCE.
- Matte black and gloss black vinyl are sourced from a German company.
INSTRUCTIONS
A heat gun or hair dryer is recommended for installation. This will make it easier to wrap the vinyl around the edge of your fender. It will stick with ease. Other than that, you want to clean the application area, including the area where the vinyl will wrap around the fenders.
Keep a mixture of soapy water handy. You will want to apply this to the back of the vinyl. It allows you to slide the vinyl around to get the perfect fit and gives the air a way to get out from under the vinyl. Once you have it in the right place, just use your fingers to push out the air and water. After this part is complete you will finish up by doing the trail edge. Go ahead and open your door so you can reach into this area. Use a little heat before your wrap it around the trail edge of the fender. It doesn't require a lot. Press the vinyl with your fingers, making sure it is secure, behind the fender.