3D Carbon Fiber Speedometer Cluster Trim Overlay
The speedometer cluster has a strange finish to it. It's almost like a matte black, primer texture. Transform it to a carbon like appearance with these overlays.
Add some texture to the interior of your vehicle Sticker Fab make a number of products for these vehicles. The 3D carbon vinyl is easy to apply and really durable. Protect areas against scratches and cover up old scratches.
NOT ALL MATERIALS ARE CREATED EQUALLY
When purchasing vinyl overlays, keep in mind that not all materials are created equally. I use premium vinyl which has high initial costs, but are the industry standards for high quality materials. Also made in the USA. - Dragon Wrap™ Carbon Fiber Films (3D Carbon) is a 5.6 mil calendered vinyl film featuring a clear repositionable permanent acrylic adhesive on an air-egress liner. This film has excellent dimensional stability, outstanding durability and outdoor performance. - This repositionable permanent adhesive offers minimal initial bond growing to permanent bonds that facilitates application of large graphics. The air egress liner also aids in large graphic application. - Minimum application temperature is 40 degrees Fahrenheit. - Up to 5 year durability outdoors. Rated EXCELLENT for WATER RESISTANCE, HUMIDITY RESISTANCE, and SOLVENT RESISTANCE.
Care Details: Concept Carbon Fiber film should be maintained to preserve long term appearance using standard aftercare products designed for textured exterior vinyl surfaces. A commercially available protectant such as Armor All or 303 Aerospace Protectant is recommended. DO NOT use waxes of any type.
Clean the application area and make sure it is clear of any dirt, debris, and/or Armor All. You want to start with the top OR bottom. The finished product will overlap slightly (1 to 2 mm). The adhesive is also pressure activated. Just keep that in mind. Finding the center is really the key to installing these. Apply the center and work it one side at a time. You can gently guide the material as you apply it. All you need is to use your fingers though. We don't recommend a squeegee or anything hard. The material is forgiving and can gently be pulled back up if you need to realign it.
If you are having alignment problems, the trim is only held in with two screws. You can remove those and pull the trim piece out in seconds. Then you can work on it off the vehicle and without a steering wheel in the way. If this is still not working for you, use some soapy water to make the adhesive not as sticky. Then you can slide it around a bit, but you will probably need a heat gun to dry up the adhesive and make it really sticky again.