Classic Bronco Logo 6" Stickers
These 6" stickers come in sets a set of 5. We have put them on our fenders and rear door which leaves us 2 extra in case anything happens.
This classic heritage logo is just a little throw back to the earlier days of the Bronco.
Grid transfer paper is pre-applied for easy alignment. We have also marked the center of the logo for you.
Clean the application area and apply the sticker using the pre-installed transfer paper.
NOTES: We recommend that the installation area be free of wax and not under direct sunlight. Since the actual lettering is narrow, the wax can make it difficult for the vinyl to stick to the vehicle versus the transfer paper. We use grid paper to make it easier for you to align.
Some will choose to clean the application area with rubbing alcohol which is okay.
"Rubbing alcohol will not damage car paint if it is diluted to between 10% and 15%. Since rubbing alcohol evaporates quickly, it doesn't damage car paint."
We have included photos of how we aligned our stickers. You can see that we used a couple pieces of paper and scotch tape. This allowed us to make a perfectly horizonal line above which we put the decal.
Then we measured a point of reference and installed it on the other fender. One of the photos, you can see that we personally installed it around 7.5" below the crease in the fender.
We eyeballed what we thought would look good below the pony on the back. What you do not see in all these photos is that we now mark the centerline of the sticker to make it easier to install.