Seatbelt Retention Buckles
Ever had your seat belt buckles slap the side of your vehicle? This can happen when the windows are down, top is down, doors are removed, rear seats are down or any combination of those situations.
These seatbelt retention buckles are easy to install and keep the buckle from moving. Leaves you with a clean look and potentially less noise.
Comes with pre-mounted authentic 3M. For customers living in extreme environments (cold, hot, or humid), we recommend purchasing 3M adhesive promoter to apply to the application area prior to installing these. Use it ONLY in the area of application that will be covered by tape.
NOTE: 2 Door vehicles only come with a passenger side retention buckle for the front (1). 4 Door vehicles comes with passenger front and rear + driver's side rear buckle (3).
Why no retention buckle for the driver?
Put your seatbelt on while you drive. You'll live longer!
Clean the application area and make sure it is free of dirt, dust, debris, Armor All, etc.
You may use an isopropyl alcohol wipe to prep the area as well. For customers living in extreme environments (cold, hot, or humid), we recommend purchasing 3M adhesive promoter to apply to the application area prior to installing these. Use it ONLY in the area of application that will be covered by tape.
Install in a very warm environment (70-80 degrees) and REFRAIN from use for 24 hours while the bond strengthens.
After application, the bond strength will increase as the adhesive flows onto the surface (also referred to as “wet out”). At room temperature approximately 50% of ultimate bond strength will be achieved after 20 minutes, 90% after 24 hours and 100% after 72 hours. This flow is faster at higher temperatures and slower at lower temperatures. Ultimate bond strength can be achieved more quickly (and in some cases bond strength can be increased) by exposure of the bond to elevated temperatures for 1 hour).
Please watch our video for additional details.
The seatbelt buckles work as advertised I love them! I was driving with the top open and they were just as advertised it was wonderful, nice and quiet nothing bouncing all over the place it was great I love it.
These Seatbelt Retention Buckles from StickerFab are great at reducing seatbelt Vibration due to wind due to the windows being down or the soft top is back or all the way down. Pleased with the product it does what it was design to do, thanks StickerFab for the fast delivery. Bronco Sasquatched Badlands 4-Dr.
These do what they say, but there is still some pretty good vibration from lower belt with these on. But noise is cut in half with these.
These worked way better than expected. I put them slightly higher than seen in the video and it worked very well
Add 3m adhesive promoter to stick properly otherwise it will fall off
Seatbelt Retention Buckles (Set of 1 or 3) - 2021+ Bronco 2 / 4 Door
So I like the concept around these. However, there are a couple issues that have occurred since installing. The biggest one is that there is still a lot of movement coming from the belts. I think if these were constructed a bit taller and longer, not thicker, they would securely hold more of the belt. Next, if your passengers do not know they are there, then they pull and the whole thing comes off. Right now I am looking for more 3M double sided tape to put on one to give it another go. Sadly not a fan considering the money spent.
The adhesive needs to be a bit stronger.