The side vents frame both ends of the dash, so their factory finish shows up every time you get in. These two overlays turn the surrounds black, sharpening the look and adding contrast to the interior.
They sit over the factory trim, so the original design stays intact: no cutting, no wiring, no permanent changes to the dash.
Built from Tough ABS
Both pieces are injection molded from high-strength, impact-resistant ABS plastic, so they hold their shape and fit through heat, cold and daily use. They attach with automotive VHB tape (visible in the photo) for a strong, clean bond.
For the best result, install while the vehicle interior is between 70 and 100 degrees F.
Before & After
Installed on the Dash
Easy Installation
Clean each vent surround, test fit the piece, remove the tape backing and press it firmly into place. Install with the interior between 70 and 100 degrees F. Watch the walkthroughs below before you start.
Left and right side A/C vent trim - sold as 2 pieces (center piece not included)
Shipping & Returns: Backed by our 30-day return policy. Made in the USA with the 3M VHB tape ready to go. Not sponsored by or affiliated with Toyota.
FAQ
Will this fit my 4Runner as well as my Tacoma? Yes. These overlays are made for the dashboard air vents on both the 2024+ Tacoma and the 2025+ 4Runner. The install photos on this page show a Tacoma.
Does this include the center vent piece? No. This listing is the 2 side pieces only. The center trim is sold separately, or you can save with the 3-piece kit.
What temperature should I install it in? Install with the vehicle interior between 70 and 100 degrees F so the VHB tape bonds properly.
What is it made of? Injection-molded, high-strength and impact-resistant ABS plastic in black.
How do they attach? With VHB tape. Clean the area, test fit, remove the backing and press firmly.
Is it affiliated with Toyota? No. This is an aftermarket accessory made by AJT Design and is not sponsored by or affiliated with Toyota.
