3D Carbon Door Sill Overlay Part 2 (Upper) - 2022+ BRZ / GR86
Protect a scuff-prone factory trim panel and add a deep, textured carbon look — with a premium 3D carbon fiber vinyl overlay, precision-cut to order by StickerFab in Fort Myers, FL for the 2022+ BRZ / GR86.
Just so it's clear: "3D Carbon Fiber" is our name for a premium textured vinyl film — a flexible carbon-look overlay that conforms to your trim. It is not real carbon fiber and it's not a hard replacement part. You get the rich 3D carbon look (and scuff protection) at a fraction of the cost of a hard part.
Protects a Piece That Takes a Beating
Factory soft-touch plastics and trim panels scuff and scratch far too easily. This overlay takes the abuse for you — it shields the trim underneath from everyday wear while giving it a deep, textured 3D carbon-fiber appearance. You protect the panel and upgrade the look in one step.
Premium Vinyl, Made in the USA
Each piece is cut to order from premium 3D carbon fiber vinyl — the same high-standard film we use across our overlays, sourced from US and European suppliers. It's durable, dimensionally stable, and built to last for years.
Cut and shipped from our shop in Fort Myers, Florida — a real product made by real people, made to order.
Not All Materials Are Created Equal
We use premium vinyl with a repositionable permanent adhesive on an air-egress liner — forgiving to apply, dimensionally stable, and built to hold up over the long haul.
🔧 Installation
Install in mild, 75–85°F weather. We recommend a dry install: clean the surface so it's free of any residue or protectants (like Armor All), apply the piece, and press it down firmly. The adhesive activates with heat and pressure, so light heat from a hair dryer or heat gun helps it conform.
For the 3D Carbon material, do not wax it. Clean with normal soap and water.
Installation Video
FAQ
Is this real carbon fiber? No — "3D Carbon Fiber" is our premium textured vinyl overlay. It gives you the deep 3D carbon look and protection of a flexible film, not a hard carbon part.
Will it fit my car? It's precision-cut for the 2022+ BRZ / GR86.
Is it hard to install? No — it's a forgiving install. Clean the surface, apply the piece, and press it down. The adhesive activates with heat and pressure.
How do I care for it? Do not wax it. Clean with normal soap and water.
Is this made in the USA? Yes — cut to order by StickerFab in Fort Myers, Florida from premium US/Euro-sourced vinyl.
3D Carbon Door Sill Overlay Part 2 (Upper) - 2022 BRZ / GR86
E
Emmanuel Skamangas (Fredericksburg, VA, US)
Good looking product, fairly easy installation, but some scratches.
I bought these because I occasionally transport my dog and she was scratching up the factory door sills. These overlays covered the door sills well, but I've noticed some scratches already. Hopefully they will hold up better than the factory parts did.
