Version 3.0 Tail Light Overlays
You probably won't see many printed tail light overlays on the market. For this version we give you a dark outer band and red in the middle.
Check out the look and contact us if you want to see other designs! We have full color printing capabilities.
Details
- Dark outer band
- Red Inside
Available with gloss or matte finishes.
INSTRUCTIONS
Clean the application and surrounding areas prior to applying. We recommend the following items for installation:
- Microfiber
- Detailing Spray or glass cleaner
- Soapy Water (StickerFab Application Fluid recommended)
- Heat Gun or Hair Dryer (optional)
Make sure there is no wax on the lens. You can wet the back of the vinyl with a few drops of dish soap in a cup of water. This allows you to slide the vinyl around into the right position. Once you have found that position, use your fingers to push out the soapy water. Allow to dry. LOW heat can be used to dry out the vinyl quicker.
NOTE: Items printed in clear material may appear foggy after initial install. They can require days to fully dry and become clear again.
