Laser Series Acrylic Fuse Box Cover Overlay - 2021+ Bronco / 2024+ Ranger
€19,95 EUR
- Easy to install with pre-applied 3M
- High gloss finish
- Acrylic piece, laser cut and engraved
The plain plastics under the hood of your Bronco can be spruced up with a fuse box cover overlay. We're just getting started, and with your help, we can come up with some pretty cool stuff!
Fun (or not so fun) Fact: The Distressed American Flag design takes 1:30 hours of processing time alone!
Installs easily with the pre-installed 3M.
While StickerFab caters to a large number of people, it is still possible to customize some orders. Ideas that have broad appeal are the best! However, if you have some art work, we may be able to do a special print just for you.
Please refrain from submitting trademarked content unless you have the rights to it. We are located in Fort Myers, FL if you are interested in helping us create custom templates for other vehicles or trim levels.
Use our contact form to get in touch with us.
Install in 75-85 degree weather. Remove the fuse box cover and clean it. Check the alignment of the acrylic piece. Then remove the backing on the 3M, carefully re-align and then press down firmly.
Ideal tape application temperature range is 70°F to 100°F (21°C to 38°C). Initial tape application to surfaces at temperatures below 50°F (10°C) is not recommended because the adhesive becomes too firm to adhere readily. However, once properly applied, low temperature holding is generally satisfactory. The bond strength of 3M™ Adhesive 300LSE increases over time and temperature. At room temperature, 50% of the ultimate strength is achieved after 20 minutes, 90% after 24 hours, and 100% after 72 hours.