i-FORCE MAX Badge Blackout — 2024+ Toyota Land Cruiser
The OEM Toyota overlay that kills the last piece of chrome on your LC250's liftgate.
Why the i-FORCE MAX Badge Stands Out
The 2024+ Land Cruiser 250 wears a surprisingly clean exterior — but Toyota left one piece of chrome right on the rear liftgate. The i-FORCE MAX badge sits dead center in a sea of black trim, and it catches every stray ray of sunlight whether you want it to or not.
This Toyota OEM overlay (part #PT948-60250-02) is the factory solution. It's molded in gloss black ABS to fit over the existing badge precisely — covers the lettering, leaves the circle element intact. The result is a cohesive, blacked-out liftgate with zero chrome break.
|
 |
OEM Fit, Zero Compromise
Because this is a genuine Toyota accessory, not an aftermarket piece, the fit is exact. No trimming, no adjusting, no guessing. The overlay slips over your factory badge and the 3M adhesive holds it there permanently.
Whether you see it as iForceMAX, i-Force Max, or i-FORCE MAX — it's the same badge, and this is the OEM Toyota answer for it. Dealers sell this at a markup. You're getting it direct.
|
 |
⚙️ Installation — Under 5 Minutes
Clean the i-FORCE MAX badge on your liftgate with isopropyl alcohol and let it dry. Test-fit the overlay before committing — it should seat with zero gaps. Peel the 3M backing and press firmly with even pressure for 30 seconds. Best done at 75–85°F for the strongest initial bond. That's it.
FAQ
|
What years does this fit? 2024 and 2025 Toyota Land Cruiser (LC250 / 250-series). Does not fit older Land Cruiser models.
|
Is this a genuine Toyota part? Yes — this is Toyota OEM accessory PT948-60250-02. The same piece sold at Toyota dealerships, not an aftermarket replica.
|
|
Does it cover the whole badge? The overlay covers the "i-FORCE MAX" lettering. The circular Toyota emblem element remains visible — by design.
|
Is it removable? The 3M adhesive is designed for a permanent bond. It's not intended to be swapped in and out, but it can be removed carefully with heat if needed.
|
|
What does it look like after install? Gloss black — matches the painted black trim on the liftgate. No chrome break. Clean, factory-level finish.
|
Why not just Plasti-Dip the factory badge? Plasti-Dip is a spray-on rubber coating — it peels, hazes, and doesn't hold gloss over time. This is a molded ABS overlay with a factory finish. Not the same.
|
Notice of Non-Affiliation and Disclaimer: StickerFab is not affiliated, associated, authorized, endorsed by, or in any way officially connected with Toyota Motor Corporation or any of its subsidiaries or affiliates. The names Land Cruiser, i-FORCE MAX, and related marks are registered trademarks of their respective owners.