Sun Visor Airbag Label Overlays - 2025+ 4Runner
39.00 SAR
Earn [points_amount] when you buy this item.
- Cover up your ugly airbag logos
- Instructions below
Earn [points_amount] when you buy this item.
Knock out the air bag warning labels on your vehicle. Please read them before you do though. You can't sue us because you wanted to cover them up. We assume you have a good memory.
StickerFab is not responsible for you forgetting what the labels said. By installing these, you acknowledge that you have committed them to memory. Also note that depending on the age of your vehicle and exposure to sunlight, removal of these stickers may remove parts or all of the airbag sticker.
NOTE: Set of 3 overlays. Two for driver side and one for passenger side. Matte black comes with one extra set as it is not air egress vinyl.
Since the factory sun visor is cloth, these had to be made to very tight dimensions. For this reason a wet install is very necessary.
Recommended items:
Clean the application area and apply the vinyl using a dry installation. Make sure the area is clean and free of dust, debris, dirt, Armor All, etc.
Make sure the installation area is completely dry before attempting an install. Because the main portion of the sun visor is cloth, these were made as close to the original label size wise. This is so no portion overhangs and comes into contact with the cloth. Any overhang can result in the vinyl peeling up around the edges in extreme, prolonged heat.
Try doing the install in the shade especially if it is warm. Ideal install temperature is 75-85 degrees. Use AC / heater as needed to bring the inside temperature to the proper level. Wet the back of the vinyl so that you can easily move it around if needed. Use a credit card or felt tip squeegee to push the air / water out.
Allow to dry.