Printed Series 1L Tail Light Overlays
The printed series allows us to do things we could not do with the original tail light overlays. While those are a great choice the masses, these allow for a little more customization.
Here's what we have so far:
- Bigfoot / Sasquatch
The entire overlay is printed along with the tint. This allows us to dial in different designs and colors all at once.
Covered in 2.5mil laminate for long life.
Please contact us for other design inquiries. If your design has some mass appeal, we will get it listed! We can do designs for the entire piece or little Easter eggs like the Bigfoot / Sasquatch.
Installation
Clean the application area and apply the vinyl using wet installation. Make sure the area is clean and free of dust, debris, dirt, Armor All, etc.
Some will choose to clean the application area with rubbing alcohol which is okay.
"Rubbing alcohol will not damage car paint if it is diluted to between 10% and 15%. Since rubbing alcohol evaporates quickly, it doesn't damage car paint."
Try doing the install in the shade so it doesn't heat up the vinyl rapidly. Video coming soon.
Keep a dish of soapy water (1 or 2 drops of dish / hand soap with a couple cups of water) around. You will want to wet the tail light and the back of the vinyl.
Also recommend using a felt tip squeegee. Now you also have the option to use StickerFab application fluid which is optimized for vinyl installation.
Removal
To remove after item has been installed for a while, please use Goo Gone and a clean towel / paper towel. This will dissolve the remaining adhesive. Be sure to rinse / wash the area after removal.
