Rear Hitch Cover with Red Lambda — 2024+ INEOS Grenadier
A simple upgrade that makes the Grenadier's rear end look as intentional as the rest of the truck.
The Detail the Factory Left Out
The Grenadier's rear hitch receiver is functional — but bare. This cover gets placed over the receiver and bolts on with the included hardware, giving the rear end a clean, finished look centered on the iconic red Lambda (Λ) badge.
The Lambda is already the defining mark on the Grenadier's front grille. This brings it around back — a subtle, cohesive detail that ties the front and rear of the truck together and signals that you paid attention to the whole build, not just the obvious parts.
Made in the USA. Bolt-on, no modification required. Takes about two minutes to install and the same to remove if needed.
|
 |
 |
Installation
Couldn't be simpler:
- Place the cover into the factory hitch receiver opening
- Align the bolt holes
- Thread the supplied hardware and hand tighten — done
No tools beyond the supplied hardware. No drilling, no adhesive, no modification to the vehicle. Fully reversible.
Fits: 2024+ INEOS Grenadier — Station Wagon and Quartermaster (all trims)
|
FAQ
|
Does this require any modification to the Grenadier?
No — it gets placed onto the factory hitch receiver and bolts on with the supplied hardware. No drilling, no adhesive, no permanent change to the vehicle.
|
Will it interfere with towing?
This is a decorative cover for when the hitch is not in use. Remove it before attaching a trailer hitch or tow ball. It takes about 30 seconds to remove.
|
|
Does it fit both the Station Wagon and Quartermaster?
Yes — fits all 2024+ INEOS Grenadier configurations including the Station Wagon and Quartermaster, all trims.
|
What's included?
The hitch cover with red Lambda badge and all hardware needed for installation. No additional tools required.
|
