StickerFab Application Fluid (50ml)
€4,95 EUR
Earn 28 Points when you buy this item.
Earn 28 Points when you buy this item.
This is the application fluid you were looking for. Better than any mixture of soapy water, it allows for easier installations in a slightly wider range of temperatures.
It turns novices into at least intermediate level installers. The initial surface tension of the sticky vinyl gets broken so you can dial in your alignment. Push the fluid out and you are left with a spot on install.
Non-flammable.
Shake before use. Use in the shade if it is sunny and warm.
We recommend you clean the installation area with this application fluid OR a detail spray that doesn't have wax and THEN this application fluid if the area is really dirty. Use a microfiber cloth to wipe dry. Spray the back of your vinyl and then proceed like we instruct you in many of our installation videos. Align, install, and squeegee or push out the remaining application fluid from under the vinyl. Allow to dry. Use of LIGHT heat can accelerate the initial bonding period.
If used with transfer tape, be sure the vinyl is dry enough to peel back the transfer tape without removing the vinyl (2-3 minutes after pushing as much application fluid out as possible).
Works when used as instructed.
While I've read that a dish soap and water mix work for a wet application of vinyl decals, I wanted to be sure mine stuck and this fluid really did the trick! Bottle sprays well and I have plenty left over for another application. Smells nice, too!
Stickerfab has made it really fun and easy to add necessary customization to you vehicle and enjoy it more. My Bronco Sport looks so much better now and I’m happy with the results. Highly recommend!
My urban assault decals were exactly what I needed to take my Pro 6 light bar to the next level! The decals went on with ease, with the help of the spray. Great product!
Couldn't have asked for any better. Chris was very helpful. Stickers are great quality. Couldn't have asked for anything more. Ordered 3 different sets of decals and satisfied with all!
I am by no means good at putting stickers on anything. This liquid did help tremendously. I was able to remove and reset a few times on some of the KC light cover stickers. If I didn't have this I can only imagine how might light bar would look...
Best formula around. Makes applying vinyl stickers with no wrinkles or bubbles easy. Used it to put stripes/protectors down near the rocker panels on my Bronco. Looks great.
The StickerFab application fluid is a must for any wet install. I only wish it came in a larger size, as I’ve tried to make my own in the past and it just doesn’t have the same consistency.
