2018-2026 Jeep Wrangler JL Auto Start/Stop Eliminator - 4DTech
The 4DTech Auto Start/Stop Eliminator is the easiest, most reliable way to permanently disable the annoying auto start/stop system on your 2018-2026 Jeep Wrangler JL. Unlike pressing the button every time you start your Jeep, this device memorizes your preference so start/stop stays off every single start, automatically.
Compatible with all gasoline and diesel Wrangler JL trims. NOT compatible with the Wrangler 4xe hybrid models. If you own a 4xe, this product will not function on your vehicle.
This plug-and-play device installs in minutes with zero tools. It connects inline at the 8-pin gateway module plug located below the steering wheel. No cutting wires, no programming, and no effect on your factory warranty or remote start function.
Installation
Locate the 8-pin gateway module plug below the steering wheel. Unplug the factory connector, plug the 4DTech eliminator inline between the factory wire harness and the module, and you are done. No tools required. The entire install takes under 5 minutes and is fully reversible.
Fitment Note
Fits all 2018-2026 Jeep Wrangler JL models with gasoline and diesel engines. NOT compatible with the Wrangler 4xe hybrid.
Frequently Asked Questions
Does this work on the 4xe hybrid? No - not compatible with the Wrangler 4xe hybrid. Fits gasoline and diesel only.
Where does it install? At the 8-pin gateway module plug below the steering wheel. No tools, no trim removal.
Will it re-enable if I want start/stop back? Yes - use the auto start/stop button on your dash to re-enable any time.
Does it affect remote start? No - remote start works normally.
