3D Carbon Exterior Lower Door Protection Kit - 2015-2021 WRX / STI
Protect a scuff-prone factory trim panel and add a deep, textured carbon look — with a premium 3D carbon fiber vinyl overlay, precision-cut to order by StickerFab in Fort Myers, FL for the 2015-2021 WRX / STI.
Just so it's clear: "3D Carbon Fiber" is our name for a premium textured vinyl film — a flexible carbon-look overlay that conforms to your trim. It is not real carbon fiber and it's not a hard replacement part. You get the rich 3D carbon look (and scuff protection) at a fraction of the cost of a hard part.
Protects a Piece That Takes a Beating
Factory soft-touch plastics and trim panels scuff and scratch far too easily. This overlay takes the abuse for you — it shields the trim underneath from everyday wear while giving it a deep, textured 3D carbon-fiber appearance. You protect the panel and upgrade the look in one step.
Sold as a 4-piece set — enough to do one whole vehicle.
|
Premium Vinyl, Made in the USA
Each piece is cut to order from premium 3D carbon fiber vinyl — the same high-standard film we use across our overlays, sourced from US and European suppliers. It's durable, dimensionally stable, and built to last for years.
Cut and shipped from our shop in Fort Myers, Florida — a real product made by real people, made to order.
|
 |
Not All Materials Are Created Equal
Our 3D Carbon is Dragon Wrap™ Carbon Fiber Film — a 5.6 mil calendered vinyl with a repositionable permanent adhesive on an air-egress liner. Excellent dimensional stability, up to 5-year outdoor durability, and rated excellent for water, humidity, and solvent resistance.
Review below is from a StickerFab customer about a different 3D Carbon product made from this same premium material — shared to speak to the material quality, not this specific item.
"Got them just now, thanks for including a(n) extra set! I've had 2 sets of CF look ones from another seller and silver stars kept peeling and the carbon look faded really bad." — StickerFab customer
|
🔧 Installation
Install in 75–85°F weather. A wet install is recommended: spray the surface and the back of the vinyl with StickerFab fluid so you can slide it into place, work out the fluid from the center outward, then set the adhesive with light heat from a hair dryer or heat gun. Work up the heat slowly — if it would burn you, it can burn the material.
For the 3D Carbon material, do not apply wax — clean with normal soap and water.
Recommended items:
FAQ
|
Is this real carbon fiber?
No — "3D Carbon Fiber" is our premium textured vinyl overlay. It gives you the deep 3D carbon look and protection of a flexible film, not a hard carbon part.
|
Will it fit my car?
It's precision-cut for the 2015-2021 WRX / STI.
|
|
How many pieces come in the set?
4. One 4-piece set is enough for a single vehicle.
|
Is it hard to install?
It's a forgiving wet install — reposition with StickerFab fluid, work out the fluid, then set it with light heat.
|
|
How do I care for it?
No wax. Clean with normal soap and water.
|
Is this made in the USA?
Yes — cut to order by StickerFab in Fort Myers, Florida from premium US/Euro-sourced vinyl.
|
