Don't hide your Toyota pride on your 6th Generation 4Runner. Add some styling and make the rear logo pop. Easy to apply. These are cut from 1/8" acrylic. Please see the video below as they have very specific install steps and notes.
NOTE: Tri-bar version is TWO Red "TO", TWO Orange "YO" , and TWO Yellow "TA".
Notice of Non-Affiliation and Disclaimer:
StickerFab is not affiliated, associated, authorized, endorsed by, or in any way officially connected with Toyota, or any of its subsidiaries or its affiliates.
The name 4Runner as well as related names, marks, emblems and images are registered trademarks of their respective owners, including Toyota.
Looks good, the o is kinds wonky but over all it gets the job done.
The letters are a nice touch to add contrast to the rear hatch. All they letters fit nice, but the "O"s were a problem. They fit in one direction only because of the center cut out. Even after aligned correctly, it would not sit flush in the recess. Not matter what I tried it would rock up and down. So only one half would stick and the other end wouldn't. I tried using a heat gun to soften the acrylic to it can bend a bit to fit, but I was worried about causing damage to the hatch and stopped. You can see the bottom of the O lifted off the panel a bit in the photo. It was less noticeable this way but it's not 100% stuck on. So I'm a bit worried that it could catch towels or something during a wash and get ripped out.
