3D Carbon Fiber Dash Overlays
3D Interior Touch
The 2015-2021 WRX / STI have a few trim pieces inside the cabin which are hydro dipped from the factory. While this gives the interior a sporty look, it can leave a little more to be desired. Other Subaru models actually have carbon fiber textured vinyl laid over interior trim pieces. This package provides precut vinyl which you overlay on top of the factory trim pieces to enhance the look and feel.
Installation requires a little skill, however two full sets are provided. This allows you to learn how the material responds to heat and stretching. Please see the additional tab for more details.
NOTE 1: S207 badge is NOT included. Covers BOTH driver side (small) and passenger side (large).
NOTE 2: You MUST have the original silver or hydrodipped carbon trim pieces that have the same shape as the photos in this listing. The larger pieces that come in some special edition vehicles are not shaped like these and this item is not compatible with them.
Cones with a total of 2 sets. One is a backup set. 4 pieces total.
- Heat gun or hair dryer
- Plastic trim tool or small screwdriver wrapped in painter’s tape to prevent damaging the trim
Carefully remove the plastic trim. This installation is meant to be done off the vehicle. Clean the trim and make sure there is no Armor All or similar residue on the pieces.
Center the overlay on the trim piece and begin to stretch it over the edges. The adhesive is activated with heat and pressure. You can use your heat gun or hair dryer for this.