Fender Vent Overlays (Upper / Lower) fits 2015-2021 WRX / STI
$22.99 USD
Earn [points_amount] when you buy this item.
Earn [points_amount] when you buy this item.
These upper and lower fender overlays are inspired by the original Varis aftermarket fenders. They give your VA WRX or STI a bold appearance and attracts attention to this fender vent area.
We have two versions with one being easier to install (original). The extended versions was created for those who have lighter color vehicles where you may want to wrap the inside of the fender a bit to prevent the paint from showing.
Sold as a SET of upper, lower, or both upper and lower.
INSTALLATION
Perform the install in warm weather (70F+). Clean the area of installation. For the extended version, make sure you are cleaning the inside of the fender where it wraps around also.
Wet the back of the vinyl with a 1 drop dish soap per cup of water mixture or use our StickerFab installation. fluid to be able to slide the vinyl into the correct position. Once that position has been found, squeegee out the rest of the water and allow to dry.
You can use LIGHT heat to press the edges down and make them stick. Vinyl reacts to heat and pressure.
Installation is made easy if you use soapy water to get your vinyl into position and then use heat and a felt squeegee to push out all the water from behind. Tucking the edge around and behind can be tricky without a tool but you can play with opening the door to gain access with your fingers
Followed the instructions and it was easy. 3D Carbon looks really good!
V2 Extended Fender Vent Upper and Lower Overlays - 2015-2021 WRX / STI
Fantastic quality, install can be a little tricky butnjust take your time. Simple change makes the car look 1000 times better
Very happy with the vinyl products purchased from StickerFab
Was looking amazing while installing, but mine seemed to have no adhesion and wouldn’t stick. Everything was prepped well and I’ve done vinyl a million times, but unfortunately these didn’t work out…hood scoop inlay went smooth and is AMAZING though.
*** Have to update this review: I was contacted about my issue with the adhesive and sent replacements, which the USPS butchered, emailed them and StickerFab but never heard from USPS. StickerFab got back to me the next day and sent me replacements for the replacements even though it was no fault of theirs. I don’t think I’ve ever had a better CS experience than with this company and would recommend them to absolutely anyone for anything they make/sell. I haven’t put the fender vent vinyl on yet, but the hood scoop inlay I installed looks awesome and is top notch quality. I will never consider buying any type of vinyl product from anyone other than SF. 👌👌👌
If you have any experience with applying decals, which these are…I applied these side vent fender upper and lower overlays on my 2021 Subaru WRX.
First cleans sides with alcohol and the use a spray bottle with washer and baby shampoo mix. This allows you to manipulate the decals and get them
In the correct place without ruining the decals. Get them set, and the lightly squeegee them to remove the water to allow them to set in place. Took me a total of 10 mins to do with sides getting them I. Place. Allow to dry about the same amount of time as you would after
Your windows are tinted
makes my car stand out yes i love it thank you
