Smoked or Red Aftermarket F1 Overlay
OLM has produced the first round of aftermarket F1 / Rear lamps for the new Supra. Some customers have very specific tastes and will want to make the lens on their lamp a little darker or even red.
Light smoke is not pictured, but is approximately half as dark as dark smoke.
Clean the application area and make sure it is clear of any dirt, debris, and ideally wax. We recommend using a wet installation. Mix one drop of soap with a cup of water. Use this on the back of the vinyl and the lens.
Center the overlay and slowly push down the center of the overlay while keeping the ends up. Once you are convinced of the correct alignment push air out from the center until the entire overlay is installed. A hair dryer can accelerate the drying out process and increase the adhesive on the back of the vinyl. Once the soapy water dries up it will be very sticky again.