Two ways to tint your fogs. Clip-in acrylic or wet-apply vinyl — same result, different install.
Two Versions, One Goal
These fog light overlays are precision-made for the 2024+ Toyota Tacoma factory fog light housings. They change both the light output color and the daytime lens appearance — giving the front end that amber, yellow, smoked, or tinted look without touching the wiring or the bulbs.
You choose the format based on how you want to install:
Acrylic V2 ($24.99) — hard lens, clips directly into the factory housing. No adhesive. Clips in, clips out.
Vinyl ($9.99–$13.99) — thin film applied wet to the lens surface. Conforms to any shape. Extra backup set included.
Amber, Yellow, Smoked, Purple, Prismatic Pink, Green
Amber, Deep Amber, Yellow, Dark Smoke LX+
Price
$24.99
$9.99 – $13.99
Extra set included?
—
Yes — backup pair included
Best for
Clean look, quick swap, no mess
Budget-friendly, any lens shape
Acrylic V2 Color Options
Amber
Yellow
Smoked
Purple
Prismatic Pink
Green
Prismatic Pink looks amber/orange during the day and shifts to pink at night. Smoked creates a stealthy dark look during the day while still transmitting light at night.
Installation Videos
Overview — all styles
Acrylic V2 clip-in install
Color comparison
Prismatic Pink in action
Acrylic V2 — Installation
Clean the original lens. Slip the bottom tabs behind the bumper cover, then press the top in — all 4 tabs should be seated behind the plastic. To remove, apply upward pressure on the bumper cover and work the piece back out in the reverse direction. Remove the protective paper last.
Vinyl — Installation
Clean the lens surface with wax-free detailer. Use StickerFab Application Fluid or 1 drop dish soap in a cup of water. Spray both the vinyl and the lens. Slide into position, squeegee from center out. Apply light heat to edges if needed. Allow to dry in sun.
The extra set can be saved as a backup or layered on top for a darker tint.
FAQ
Will these fit the 2025+ 4Runner? Yes — the fog light housing is identical between the 2024+ Tacoma and 2025+ 4Runner. Shop the 4Runner listing here.
Are these compatible with RIGID aftermarket fogs? No — the Acrylic V2 will not fit RIGID Pro or Trailhunter lamps at all. The housing geometry is completely different and there is no modification that will make it work. Vinyl versions can potentially be made to fit but would require trimming to size.
Which color gives the most amber output? Standard Amber gives saturated amber output. Deep Amber vinyl is even more intense. The tradeoff is slightly reduced raw brightness.
What does Prismatic Pink look like? Amber/orange during the day, shifts to pink at night. Looks different in different lighting conditions.
What does Smoked look like at night? Stealthy dark during the day, still transmits light at night — output is reduced but not dramatically. Best if you want fogs to disappear into the bumper.
Which Tacoma trims are compatible? SR/SR5 (factory fogs required), TRD PreRunner, TRD Sport, TRD Off-Road, and Limited. Not compatible with Pro / Trailhunter RIGID lamps.
Got them installed on my Tacoma. I purchased the acrylic inserts. One flaw I see being an issue is rock chips. Being so low, rocks are going to hit and shatter the acrylic. Would be a good idea to also offer some vinyl film pre installed on the acrylic lens covers. This would help keep the integrity of the product for years to come.
N
Natt C (Omaha, NE, US)
Fog light Overlays
Not too bad for wet installation you have to be patient and take your time. It's look good on my truck and I like it.
Amber
Yellow
Smoked
Purple
Prismatic Pink
Green
