Smoked Sidemarker Overlays (Front Only) - 2016-2023 Tacoma
$9.99 USD
$12.95 USD
- Low cost customization
- Easy to install
- Installation video below
When you're trying to achieve a certain theme, sidemarkers can stick out like a sore thumb. There's an easy way to make them less noticeable (light can still pass through at night), without spending a lot of money. That smoked look is achievable through vinyl.
We provide a variety of materials you can get these in. Start a theme for your vehicle and mix it with our other vinyl products.
Sold as a pair (left and right).
AVAILABLE MATERIALS
Installation video below is of a similar install. Please use it for guidance.
Items you may want to have:
Clean the application area to prepare it for installation. Do not use a spray with any type of wax in it.
The overlays are labeled on the back. Installation video is for front and rear, but this listing is for FRONT only.
A wet installation is optional. Use slightly soapy water on the back of the vinyl. This will allow you to move the vinyl around and find the correct alignment. Once aligned, use your fingers or a felt tip squeegee to push out the water/air. Allow the vinyl to dry. Once dry, make sure all the edges are adhering to the sidemarker. If they are not sticking very well, apply LIGHT heat and press them down again.