2025 Toyota 4Runner Tail Light Turn Signal and Reverse Overlays
These tail light overlays give your rear end a significant aesthetic upgrade. It knocks out the white lenses in the OEM tail light and gives it an aftermarket appearance. So little can really do so much.
We provide a variety of materials you can get these in. Start a theme for your vehicle and mix it with our other vinyl products.
AVAILABLE MATERIALS
- Dark Smoke - Standard dark smoke material. Made in Germany.
- Dark Smoke LX+ - Premium dark smoke material with air egress channels for ease of installation (helps prevents bubbles). Made in the USA.
- Light Smoke - Standard dark smoke material. Made in Germany.
- Dark Smoke Stealth - Premium dark smoke MATTE material with air egress channels for ease of installation (helps prevents bubbles). Made in the USA.
- Light Smoke Stealth - Premium light smoke MATTE material with air egress channels for ease of installation (helps prevents bubbles). Made in the USA.
- Dark Smoke Honeycomb - Premium dark smoke material with air egress channels for ease of installation (helps prevents bubbles). Modified light pattern when lit. Made in the USA.
- Dark Smoke Carbon Fiber - Premium dark smoke material with air egress channels for ease of installation (helps prevents bubbles). Modified light pattern when lit. Made in the USA.
- Dark Smoke Galaxy - Premium dark smoke material with air egress channels for ease of installation (helps prevents bubbles). A galaxy full of metallic flake in the light. Appears similar to standard dark smoke when backlit. Made in the USA.
Instructions
Items you may want to have:
- Detail Spray (without wax) or glass cleaner
- Microfiber Towel
-
StickerFab Application Fluid or dish with soapy water (few drops of dish soap + 1-2 cups of water)
Do the installation in 70 degree or warmer, sunny weather. However, keep the surface you are working on in the shade. Clean the application area to prepare it for installation. Do not use a spray with any type of wax in it.
A wet installation is required. Use StickerFab application fluid or slightly soapy water on the back of the vinyl. This will allow you to move the vinyl around and find the correct alignment. Once aligned, use your fingers to push out the water/air. Allow the vinyl to dry.
