Sticker Fab has distributed over 20,000 vinyl products in the last few years! This new platform will be a great canvas for their accents and protection items.
You'll have your vehicle looking closer to a special edition A91 Supra in no time. These are ultra easy to install and will last for a long time.
NOTE: Sold as a set. 4 total stripes. 2 for driver's side and 2 for passenger side.
3D Carbon Dragon Wrap™ Carbon Fiber Film is a 5.6 mil calendered vinyl film featuring a clear repositionable permanent acrylic adhesive on an air-egress liner. This film has excellent dimensional stability, outstanding durability and outdoor performance. This repositionable permanent adhesive offers minimal initial bond growing to permanent bonds that facilitates application of large graphics. The air egress liner also aids in large graphic application.
Lasts up to 5 years outdoors.
Other materials are sourced in the USA as well.
Care Details: Concept Carbon Fiber film should be maintained to preserve long term appearance using standard aftercare products designed for textured exterior vinyl surfaces. A commercially available protectant such as Armor All or 303 Aerospace Protectant is recommended. DO NOT use waxes of any type.
Clean the application area and have soapy water available. Use a drop of dish soap mixed with a full cup of water.
Apply some of the soapy water to the bottom of the vinyl. It will allow you to slide the vinyl around until you find the proper placement. It will also aide in removing air bubbles.
You want to get the alignment of the piece so that it contours the fenders. Start with the larger piece and use the defroster lines on the rear window as a point of reference. You will want to align the front edge of the larger piece at approximately the fourth defroster lines. Please see the photos.
Once you have to aligned, use your fingers to push out the air and water. To speed up the process of drying you can use light heat from a heat gun or hair dryer.
When the first piece is aligned, begin to apply the smaller piece. It will sit behind the larger stripe by approximately 1.5".
Repeat for the other side.