V2 Smoked Shortie Style Light Bar Overlays
We're just trying to change up the look of your headlights a little bit with this modification. For your standard headlights, these will overlay the turn signal area of the headlight. This knocks out some silver but keeps a very iconic, round headlight design.
We provide a variety of materials you can get these in. Start a theme for your vehicle and mix it with our other vinyl products.
AVAILABLE MATERIALS
- Dark Smoke - Standard dark smoke material. Made in Germany.
- Dark Smoke LX+ - Premium dark smoke material with air egress channels for ease of installation (helps prevents bubbles). Made in the USA.
- Light Smoke - Standard dark smoke material. Made in Germany.
- Dark Smoke Stealth - Premium dark smoke material with air egress channels for ease of installation (helps prevents bubbles). Made in the USA.
- Dark Smoke Honeycomb - Premium dark smoke material with air egress channels for ease of installation (helps prevents bubbles). Modified light pattern when lit. Made in the USA.
- Dark Smoke Carbon Fiber - Premium dark smoke material with air egress channels for ease of installation (helps prevents bubbles). Modified light pattern when lit. Made in the USA.
- Dark Smoke Galaxy - Premium dark smoke material with air egress channels for ease of installation (helps prevents bubbles). A galaxy full of metallic flake in the light. Appears similar to standard dark smoke when backlit. Made in the USA.
Instructions
Items you may want to have:
Clean the application area to prepare it for installation. Do not use a spray with any type of wax in it.
The overlays are labeled driver and passenger. The bar gets slightly bigger towards the center of the vehicle.
(installation video coming soon)
A wet installation is recommended. Use slightly soapy water on the back of the vinyl. This will allow you to move the vinyl around and find the correct alignment. Once aligned, use your fingers or a felt tip squeegee to push out the water/air. Allow the vinyl to dry. Once dry, make sure all the edges are adhering to the DRL bar. If they are not sticking very well, apply LIGHT heat and press them down again.