USB-A to 12V RJ11 Radar Detector Power Cord — Universal
Clean power from any USB-A port. Short for tight installs, long for A-pillar routing.
Two Lengths for Every Install Style
Some drivers route their radar cord straight from the overhead console, a few inches from the detector. Others run it under the headliner, tucked down the A-pillar, needing every inch of a 38" cord to reach cleanly.
This cord comes in both: the 12" short version (~10" cable) for close-source installs, and the 38" long version (~36" cable) for full A-pillar routing. Both work with any standard 5V USB-A port — no Quick Charge needed.
|
|
📐 Specifications
Short version: ~12" total (~10" cable + connectors)
Long version: ~38" total (~36" cable + connectors)
Connector A: USB Type-A (male)
Connector B: RJ11 barrel (12V output)
Power: Standard 5V USB-A — no QC or special port needed
Compatible: Escort Max/Redline/Passport — Valentine One Gen1 & Gen2 — Uniden R3, R7, R8 — Beltronics GT-7, GT-360 — all other RJ11-powered detectors
Frequently Asked Questions
|
Which length should I choose?
Short (12") if your USB-A port is in the overhead console or very close to your detector. Long (38") for standard console-to-windshield routing along the A-pillar.
|
Does my USB-A port need to be Quick Charge?
No. This cord works with any standard 5V USB-A port — no special requirements.
|
|
Will this work with my Valentine One?
Yes — both Gen1 and Gen2 Valentine One use the RJ11 power connector this cord terminates to.
|
What if I need even more length?
If 38" isn't enough, the OBD II cord (118" total) routes from under the dash through the A-pillar for a fully hidden install.
|
Complete Your Radar Setup
